Thanks for choosing Wedde and Sons for your parts needs. We do business the “old school” way like the old school tractors we love. All calls go to a land line phone and emails to a...
Farmall 300 air cleaner assembly, $25.00
Farmall 300 and 350 air cleaner to carburetor air intake pipe, $15.00
Battery box lid for $20.00
Farmall 300 belt pulley drive engagement rod, $10.00
Front crankshaft pulley $10.00
Front cover assembly with idler gear. These covers will allow you to put live hydraulics on an H because they are deeper to clear the pump gear, $75.00
Set of main bearing caps $50.00
Rear main seal holder $10.00
Tappit cover $10.00
Water jacket cover $10.00
Farmall 300 and 350 dash cover, $15.00
Farmall 300 distributor removed from a running tractor, $125.00
Farmall 300 swinging drawbar anchor with anchor pin, $25.00
Original Farmall 300 drawbar hoop to mounting bracket bevel headed bolts, $10.00 for the pair
Dual hydraulic levers $50.00
Farmall 300 engine mounting blocks, $25.00 for the pair
Fan shroud in decent condition $20.00
Set of 4 fan shroud mounting bolts for a Farmall 300, $5.00
Farmall H or 300-350 front adjustable style wheel hub including the bearings, $50.00 each
Original gauge panel for the dash. Panel has all the correct mounting holes and has not been butchered $25.00
One wire GM alternator removed from a running Farmall 300 tractor, working condition unknown, $25.00
Farmall 300 inspection cover, $10.00
Light rod set $25.00
Manifold from a running tractor that has had the extension pipe welded in $75.00
Farmall H or 300-350 narrow front without hubs, $50.00
Farmall H or M and others oil filler cap, $10.00
Farmall 300 and 350 parking brake latch, $25.00
Farmall 300 and 350 parking brake, $50.00
Farmall 300 and 350 air cleaner pre-cleaner with a few dents, $10.00
Farmall 300, 350 and maybe others aftermarket PTO shield in unused condition, $35.00
Farmall 300, 350 and maybe others original PTO shield in restorable condition, $35.00
Farmall 300 radiator cap, $5.00
Seat base mounting bolts $5.00 each
Farmall seat flipper removed from a Farmall 300 tractor. Flipper has minor wear and all original hinge pins present, $50.00
Farmall 300 and others seat suspension in good usable condition and not all worn out, $50.00
Farmall 350 starter removed from a running tractor, $75.00
Farmall 300 starter removed from a running tractor, $75.00
Farmall 300 or 350 front steering bolster. Bolster is in good usable condition with no breaks or weld repairs where they normally have issues. Could be the start to making a Super HTA, $100.00
Farmall 300 swinging drawbar that has a weld reinforcement. Drawbar is in very nice condition other then the repair, $75.00
Farmall 300 tall vented gas cap, $15.00
Throttle assemblies $25.00
Under gas tank toolbox with mounting studs $30.00
Triple groove front crank pulley that was fabricated $25.00
Triple hydraulic levers $50.00
Farmall 300 upper radiator support, $10.00
Upper steering mount $25.00
Farmall 300 upper steering shaft, $25.00